+- EmBitz (https://www.embitz.org/forum)
+-- Forum: EBlink (https://www.embitz.org/forum/forum-3.html)
+--- Forum: Using EBlink (https://www.embitz.org/forum/forum-6.html)
+--- Thread: EBLink error: no interface found (/thread-190.html)
EBLink error: no interface found - dave@idea-tech.com - 21-02-2024
Hi, I am a complete newbie. I have just loaded EmBitz 2.62 and EBlink 5.12 on Win 11 pro.
I have an ST Nucleo board ( STM32F303 ) connected to my PC. This board has a built in ST-Link.
I can compile a simple test program, but when I try to Flash Target, I get a 'No interface found' error.
I would much appreciate being pointed in the right direction as to what steps I have missed in the
installation or what I have not configured correctly.
Thanks!
RE: EBLink error: no interface found - embitz - 22-02-2024
You didn't missed anything. Eblink doesn't find your stlink and I don't know why.
Do you have any info about board and which stlink is used? I never used Windows 11, perhaps usblib is not yet ready for Windows 11?
RE: EBLink error: no interface found - embitz - 22-02-2024
Does STutil find the interface?
Perhaps the board is mis configured or broken.
RE: EBLink error: no interface found - dave@idea-tech.com - 23-02-2024
Thanks for re-assuring me that I hadn't missed something. I am using the NUCLEO-F303K8 with built in ST-LINK. I had been using it with another IDE just before
installing EmBitz.
I just checked again and the other IDE couldn't find the ST-LINK as well, so the Nucleo board had just coincidentally stopped working after installing Embitz.
I rebooted the PC and re-connected the Nucleo board, then tried Embitz again - and successfully able to program!
Successful with the other IDE as well.
A strange set of events, but I can now start to evaluate Embitz.
Thank You!
RE: EBLink error: no interface found - embitz - 23-02-2024
Top