Probably same kind of error. When I pressed "Session Start/Stop" then "Continue" too fast. I get the same message.. Is it possible to buffered the command until the thread is ready..
I suspect a small project won't do it since it is fast to load in device.
If you have a STM32F746G-DISCO board on hand.. you can try my ongoing project.
https://github.com/aroyer-qc/GRBL_Digini_STM32Fx
I suspect a small project won't do it since it is fast to load in device.
If you have a STM32F746G-DISCO board on hand.. you can try my ongoing project.
https://github.com/aroyer-qc/GRBL_Digini_STM32Fx