Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
STLink-V3MINI usage
#10
(26-03-2021, 04:36 AM)vorosj Wrote: I built this 3d printed box for the v3 mini, with a 3.3V LDO and 2.54mm pin headers. The yellow jumper connects the 3.3V to VTRef.

I have considered using an internal resistor to tie 3V3 to VTref so if you use the VTref pin to connect to a target at a lower voltage the VTref would still do its job.  I use a 6 pin TAG-CONNECT on my custom boards.
https://www.tag-connect.com/product-cate...pin-target
Reply


Messages In This Thread
STLink-V3MINI usage - by vdaniel - 04-03-2021, 09:34 AM
RE: STLink-V3MINI usage - by embitz - 05-03-2021, 10:17 AM
RE: STLink-V3MINI usage - by vdaniel - 05-03-2021, 02:17 PM
RE: STLink-V3MINI usage - by john.rudolph.ee - 17-03-2021, 01:53 AM
RE: STLink-V3MINI usage - by vdaniel - 17-03-2021, 09:20 AM
RE: STLink-V3MINI usage - by embitz - 18-03-2021, 09:13 AM
RE: STLink-V3MINI usage - by vdaniel - 18-03-2021, 01:31 PM
RE: STLink-V3MINI usage - by vorosj - 26-03-2021, 04:36 AM
RE: STLink-V3MINI usage - by john.rudolph.ee - 27-03-2021, 06:05 PM
RE: STLink-V3MINI usage - by embitz - 27-03-2021, 07:48 AM
RE: STLink-V3MINI usage - by embitz - 28-03-2021, 08:43 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)