23-02-2024, 12:10 AM
Thanks for re-assuring me that I hadn't missed something. I am using the NUCLEO-F303K8 with built in ST-LINK. I had been using it with another IDE just before
installing EmBitz.
I just checked again and the other IDE couldn't find the ST-LINK as well, so the Nucleo board had just coincidentally stopped working after installing Embitz.
I rebooted the PC and re-connected the Nucleo board, then tried Embitz again - and successfully able to program!
Successful with the other IDE as well.
A strange set of events, but I can now start to evaluate Embitz.
Thank You!
installing EmBitz.
I just checked again and the other IDE couldn't find the ST-LINK as well, so the Nucleo board had just coincidentally stopped working after installing Embitz.
I rebooted the PC and re-connected the Nucleo board, then tried Embitz again - and successfully able to program!
Successful with the other IDE as well.
A strange set of events, but I can now start to evaluate Embitz.
Thank You!